3d Printing tuition
So just bought your first 3d printer (or 2nd...) and are having issues.
Some of the things I can help you with are... (in the privacy of your own home)
- Assembly of your machine (some machines come "flat packed") far from a fun job but needs to be done right
- Installation of slicer software and setup of your machine
- Explanation of slicer settings and how/when to use them. A lot of issues and failures are solely to poor slicer settings
- How to maintain your machine and bed levelling. Really is straightforward but is a knack to it and needs to be seen to believe
- Bed adhesion issues. NO GLUE OR HAIRSPRAY do not use. again correctly assembled machine, settings and bed level is a must
- Setting up octoprint on a Raspberry pi
- Remote viewing and control of your machine (no dangerous port forwarding here)
- Plus lots more from general knowledge that comes from years of 3d printing
I am competitively priced and willing to travel to you
Travel distance will be at your cost (my private vehicle) but realistic prices
I am based in busselton but willing to travel as far as needed by you the customer